Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear Sir, My pc are connected to a cisco 3750 switch. Switch is configured as vlan1 ip address as 10.42.4.1 255.255.255.0 primary.And 10.42.8.1 as secondary.PC default gateway = 10.42.4.1 and PC are getting application access through switch configure...
Dear Sir, How to assign port for module NIM-ES2-8-P as vlan 2 and communicate with other sub-interface in dot1q 1 connected to switches for vlan1. In external switch we create trunk port to connect to the sub-interface of router.Is NIM-ES2-8-P by def...
Dear sir,In my cisco 4331 router following are my configuration ad from external switch it is working fine and i can access internet as well as both the vlan each other. external switch are connected to interface GigabitEthernet0/0/0 4331 router conf...
Dear Sir, My IP-PBX ip is 192.168.10.85, I am using DDNS to reach my isp modem router. I forwarded all my traffic from isp router to cisco router isr 4331. Now I want to forward port 5060 to 192.168.10.85 from wan interface ge/0/0/1also ports 6023 fr...
I have cisco switch SG550X but I am not finding the option to change this in Layer 3 mode.
Also after changing a port into Layer 3, while creating interface and I can add with ip address as dynamic, if I tried to add static IP, the system get hang we...
Dear Sir, I deleted both the sub-interface of interface GigabitEthernet0/0/0 and after thatinterface GigabitEthernet0/0/0no ip address ANDinterface Vlan1ip address 192.168.10.1 255.255.255.0ip nat inside!interface Vlan2ip address 192.168.11.1ip nat i...
Dear Sir, Sir all port of NIM-ES2-8-P is in vlan 2.interface GigabitEthernet0/0/0.1bandwidth 100000000encapsulation dot1Q 1 nativeip address 192.168.10.1 255.255.255.0ip nat inside interface GigabitEthernet0/0/0.2bandwidth 100000000encapsulation dot1...
