Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,Since I updated a Catalyst 2960 switch to IOS version 12.2(55)SE1 I can't do searchs by MAC address, when I do "Monitor->Search" the following error appears:"The software version of the selected switch does not support some of the CLI commands in ...
Hi everybodyI have installed Callmanager 4.3 and now I'm fighting with CDR Reports. Follwing intrunctions on manual I have set up on CCM machine the CAR plug-in, then I access the CAR page but I can't see any of the tool bars with the menus.I thought...
Hi everybodyI'm installing CUCM 6.1 on one of my best customers but I'm experiencing problems whn connecting the PCs to the device port on the IP phones.All the phones are connected to a 3750G-PoE and registered with the CUCM. When I attached a PC on...
Hi everybodyI'm trying to deploy a WLC 4400 with several LAP1131 but I have problems: the APs can't join the controller.Before starting this conversation, I have read the documentation, set DHCP option 60 and 43 with appropiate values, checked that I...
Hi from BarcelonaI'm trying to setup Cisco ACS to use PEAP but before that I need to configure a CA on the server. I'm following the procedure found in http://www.cisco.com/en/US/products/sw/secursw/ps2086/products_configuration_example09186a0080545a...
Hi TimI have uninstalled and installed CAR again nd now it works. The difference is that this time I have done on the local console, not via Terminal Server. That was the trickThank you very much for your interestDani
Hi TimI have restarted not only the services, I have restarted also the whole machine but no results.The CCM version is 4.3 and the CAR installed, the found on services/plugins.I have had a read on bug CSCsh45385 but it doesn't seem to be my problemD...
Hi Timit seems I have a strange ethernet cables. I have tested 3 cords that worked fine when connecting the PC directly to the switch but didn't work when connecting the PC to the IP phone. After 3 lost hours, I have decided to go to my office and co...
Hi TimI have already checked my PC NIC and it is in Auto mode (both speed and duplex). I have tried with 2 other PC with the same result. I have no link on the PCs when they are connected to the IP phoneMore ideas?DAni
Hi pirate, dennisthe problem was choosing Layer2 infrastructure. I don't know why but the APs didn't register with WLC until I changed to LAYER3 infrastructure.Anyway, thank you very much for your help!Dani
