Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear community,
In a VXLAN topology with VRFS, where routes from VRF2 or VRF3 are imported from VRF1, these routes are not being advertised to a firewall located in VRF1.
I've attached the configuration of one device.
It's as if the route isn't be...
Hello everyone,
I am trying to set up a vpc topology where I connect two borders leafsdirectly to different cpds using level 3 and vxlan. The vpc is for traditional vlans.The problem I have is that I don't see traffic on nve interface 1.
nve1 is upad...
Dear Community,
I am trying to implement a new Catalyst with SRST without direct output to the PSTN.
I want the extensions to register with it and for outgoing calls to go to an old SIP gateway and incoming calls to reach the old gateway as before an...
Dear Community,I have the following topology and I wanted to know if anyone has done a similar configuration and could you send me an example.I have a Catalyst 8200L are licensed by SRTS and UCME. This switch is Ethernet only.Then there's a VOIP Gate...
Hi all,I want to know if possible to use a breakout cable on a port of Cisco Nexus C9336PQ, i saw that other models does't support it.I tried to configure it but the port don't leave up and i don't see how configure the port to make the breakout.Than...
Hi Enes,
Hello Enes,You're right, I forgot to put them in, I'm just putting an excerpt of what I think is relevant.Thank you very much and greetings,
vrf context vrf10vni 50000rd autoaddress-family ipv4 unicastroute-target both autoroute-target both ...
Good morning,
I have added the command to the config that I had deleted and I pass it through now. Something very strange happens, Nexus 1 stops receiving the announcement of loopback 1 from router Nexus 3 if I apply loopback one on router 3 as a sou...
Hi,
Good morning,I have added the command to the config that I had deleted and I pass it through now. Something very strange happens, Nexus 1 stops receiving the announcement of loopback 1 from router Nexus 3 if I apply loopback one on router 3 as a ...
