Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear all, I have to connect two remote sites using an IPSec Tunnel (EasyVPN). The devices to be used are two Cisco ASA 5505.They have already been connected to the internet and configured and they can see and ping each other via the “outside” interfa...
Dear all,I got a problem with two ASA5505.I have to connect two remote sites using an IPSec Tunnel (Site to Site VPN). The devices to be used are two Cisco ASA 5505. They have already been connected to the internet and configured and they can see and...
Hello,I have a question regarding a 891 Series router.I know that there is a GE0 port (WAN) and a FE Routing port (FE8) and both of them are router ports.The other FE Ports (Fast Ethernet 0 to 7) can be also used as independent routed ports (maybe us...
Hi,I got 10 Catalaysts 3750 (all of them identical) and I got tthe IOS Update. Anyway I only have service contract for 4 of them. Am I allowed to update all of them? Or only the four devices which have the service contract?Thanks for your help!best r...
Hello!I am designing a network for industrial purpose, and I have some doubts designing the Rapid/Multiple Spanning Tree Redundancy.My two core switches are Cisco Catalyst 3750G but all the other devices in the network are Non-Cisco. If you take a lo...
Hi Altaf, thanks for your offering. Unfortunately due to enterprise policy I am not allowed to do this. Furthermore there is no public internet access where the ASAs are located. However, thank you very much for your offer! I took a look and read abo...
Hi Altaf, I somehow managed to find the solution for the problems I saw with the PacketTracer. I just put an ACL List permitting ip traffic in the outside interface (inbound). Apparently the traffic was being sent but not being received. Now I got a ...
Hi Altaf, it still does not work Taking a look in the packet tracer of both devices it seems that they are always dropping the incoming packets. The sent ones are sent without problems. (also after doing the split-tunnel changes!) If I change the se...
Dear Altaf, thanks a lot for your help.I will try it later since I do not have access to the server. In my site I only have access to the ASA-client. regards,Fabio
Hi Altaf, it is enough if I issue the following commands? no split-tunnel-policy tunnelspecified no split-tunnel-network-list value bb-trafficOr anything else has to be done to remove the split tunnel? Best regards,Fabio
