About gurzonijunior

gurzonijunior · 08-14-2009

HelloI am having an issue with an E1 R2-Digital connection between a CME and a Nortel Meridien 11C PBX. The Nortel and the CME are connected via E1 R2-Digital connection (unfortunatelly the Nortel doesn't have a PRI board available). The Cisco phones...

gurzonijunior · 02-21-2008

Hello.I am trying to transfer some of the incoming voip calls sent to one of our voice gateways(router) to another router, equipped with CME.I tried to follow the concepts of inbound and outbound dialpeers and hairpinning (if I understood correctly) ...

gurzonijunior · 11-27-2012

Hello.I am running into a similar issue. Would be possible to post what codec mismatch you had in more details ? Thanks a lotAngelo

gurzonijunior · 10-19-2009

Hi, Andrew. I'm having a similar issue, with 3560 switches and Vista behind the IP Phones (both 7960 and 7961 models). I was wondering if you can share the workarounds and caveats you found when installing it in your environment. In my network, when ...

gurzonijunior · 08-14-2009

Hello there. I have a similar issue. Could you post the commands you used to solve you issue ?Regards

gurzonijunior · 01-08-2009

Hello there. I had the same problem yesterday, after trying to upgrade the version of one of my CUEs. It's something (apparently) affecting the embedded bios installed on the CUE's disk. When I sent this error screen to TAC they asked me to try to re...

gurzonijunior · 02-25-2008

Belilacqua, a sharp shoot. it worked. I was missing the voice service voip allow h323 to h323 command in the router that needs to relay the calls (the 'middle' router) to the CME.tks

Member Since	‎02-21-2008 11:47 AM
Date Last Visited	‎08-18-2017 03:56 AM
Posts	7

User Statistics

User Activity

E1 R2-Digital in 2851 not receiving dialed digits

Dial peers - transfering voip incoming calls to another router

Call Transfer drops but shows connected for few seconds

Re: 802.1x clients behind Cisco IP Phones..... and the code rele

Re: Conecct E1 R2 to a router 2851

Re: Cisco Unity Express

Re: Dial peers - transfering voip incoming calls to another rout