Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I plan to have a router connected on a VPLS network, a CISCO 2951, connected via one of two the standard Ethernet port. I need to set the Layer 2 COS to the right priority for Voice. How can I do that ? Does the DSCP EF marking automatically reflects...
We need a DS3 in Italy. Our local provider says he can only deliver this on an STM1 optical, using a TUG3 of the STM1. Can we use a 7204 VXR STM1-router to terminate this, using a PA-POS-1OC3 ? or do we need to use another port adapter ?
I need a router with 2 WAN 10 Mbps Ethernet interfaces and two LAN Ethernet interfaces. Isolation between the two LAN I/Fs, for instance using two separate IP subnets. What config can I use ? I thought of a CISCO 2851 with two HWIC ESW but I am being...
Thanks for your answer. So you can do that on a Cisco 2951 with "set cos" in a policy map on a VLAN subinterface of the Ethernet port Gi0/0 ? Is that correct ?
My provider provides me an Internet backup connection IPSec protected but not end to end. I need an end to end encryption any to any, thus using Get VPN is a good solution. However I need to make it run over the IPSec of the provider. Hence my questi...
thanks - good hint... I'd like nevertheless to have the confirmation if possible that it has been indeed configured and tried, if not with with ftp, with a similar protocol, the kind of protocol with dynamic port assignment (passive mode)- difficult...
This won't work with ftp in passive mode - because the ports are dynamically assigned. Hence the need of nbar. Note that the question is also if match not protocol ftp is syntactically correct.
