Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, While issuing the command “show ip accounting” on Cisco 10720 router the output is empty.Command used for enable on serial intyerface:-router(config)#int serial 0/0router(config-if)#ip accounting output-packetsrouter(config-if)#exit But while in...
Hi, We got %RFS-3-MSG_INCOMP: ifs_issu_get_msg_mtu(): msg_type [86] under session [721130] is incompatible error on 7613 router. As per Cisco The message types are incompatible under ISSU.Please suggest the criticality and why this comes. Regards,...
Hi,,We are installing device package for switch Cat2960. But we get below error message when trying to install the same. WARNING : Cat2960(6.1):Consistency check failed for base package SharedDcmaIOS When trying to updgrade the SharedDcmaIOS to hig...
Hi,We tried to install one E1 card in Cisco 3745 router and we are getting following error. Slot 3: NM-2CE1T1_PRI Port adapter, 2 ports Port adapter is disabled deactivated We installed the same in Cisco 2821 router and getting followin...
Hi, We are facing problem in our voice gateway.All of a sudden, the incoming and outgoing pstn calls started not working. When I checked the VG,I could observe everything as registered in the VG and CCM. I restarted the VG and showing the pri Lines u...
Hi,I have already checked this on fastethernet port:-Int fa2/12ip accounting output-packetsBut output is same:-Router#sh ip accounting Source Destination Packets BytesAccounting data age is 03:01Regards,
Hi, We are using LMS2.6 and you have provided solution to install / upgrade to LMS 2.5.1We are installing the device package Cat2960.RME43.v6-1 for switch 2960 Supporting device package we are installing are SharedSwimIOS.RME43.v2-5-1SharedDcmaIOS....
