Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Experts - need your advice on following situation. We need to create a GUEST VLAN in our Meraki Setup, and my project manager requesting if we can obfuscate the public IP for Guest users. Is there a possibility with a setup where we have only Mera...
Hi - I am quite new to Meraki devices and looking for some advice/help here.I have a non-meraki VPN peer on my MX100, which I have to use to forward any traffic from a specific wireless SSID. As of now I have 3 different Wireless SSIDs available on m...
Is there any way we can check if the hot swapping of the cards is possible or not in a cisco router/switch. Please inform if there is any command for that, or any specific device series has this property.RegardsVaibhav Vishnoi
Hello,We need to know that what would be the procedure to have the VRF table and global routing table communicating with each other in a single router. Earlier we were using 2 different routers for this purpose, but now 1 router has to be eliminated....
Thanks Brash - You are correct, I have done Obfuscation using the mentioned options. Was just wondering if Meraki has any magical feature. Thanks so much for the time and updating the answer. Much Appreciated.
Thank you for the quick responses.And yes you are right wanted to tunneled all the traffic for a specific VLAN or SSID.. will try to look for some other solution. Thank you again
Thank you LasseBang for your reply. Actually it is to bisect the Internet Usage for a group of users. There is one Corporate SSID which will keep using the Native Internet using local ISP. And this new SSID will be used forward the Internet or any tr...
