Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Can anyone give me a definitive answer as to how I enable Jumbo frame support on a 4500x system?Ive enabled it on the VLAN interface and the physical interfaces dont have the command available in config mode. Thanks in advance. Iain
I have a couple of questions/issues. Firstly the ACS 4.2.1 for Windows database replication does any one have and documentation on the processes required?Secondly I have a single system installed which is providing TACACS authentication for manageme...
I appear to have an issue with supplimentary services over a QSIG link to a Mitel SK2000 PABX. The attached two files show the working call through the system and a failed call which should be forwarded onto another system through the QSIG messaging....
Can I use the ACS Network Device Groups to have a single ACS apliance acting as the authenticator for two Windows domains for 802.1x for a single switch?Hope the question makes sense but to put a little more meat on the question:i have a single ACS A...
On the Windows version there is the command line utility which allows for the bulk import of users and clients. With over 250 TACACS+ client to install on an ACS appliance I do not want to have to add them in manually, one by one, but don't seem to b...
bad choice of interfaces on my behalf! Its not on the interfaces I looked on as these are the ones in the VSS bundle.Looked elsewhere and the command is there.Need to change and test again. Iain
Thanks for the two links, with regards to the WLC authentication I can see a passed authentication in the log files and hence my confusion. The authentication appears (well its in the log file, correct username/NAS IP Address/time) to pass, and there...
the issues have been resolved by upgrading to a T train release of code later than 12.4(9), I used 12.4(15)T1.This then gives you additional configuration options such as within the dial peer pots> supplementary-service qsig call-forwardThis sorted t...
Sorry its taken a little while to get you the answer but I have been away from net access.The IOS is 12.4 17a SP Services.The call divert is supposed to take the call to another PBX within the TDM side of the network. It is given a QSIG suplimantry m...
