Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, when I connect to VPN with ASA 5510, can not connect to web applications in http instead https in other applications are working properly. how can I fix this? Thanks
Hello everyone, I have a uccx 5.0.2 with IP Phone Agent, my question is: Do I login and logout from all devices that belong to RMCM? when I create in the end user agents, how many devices can I attach? I tried to insert 5 mac Controlled Devices, but ...
Hi, I have a problem with UCCX CUCM 5.0 and 6.1. The system works on 50 locations, and then there are more than 100 partition but only for internal calls (Interni). I installed the UCCX and I quote both the CTI route point that the port on the same p...
Hi, I need help with programming on a CUCM 6.1.2 and I do not know if this is possible. However I have a 2000 int device that I have to configure as follows: must have the ability to make internal and external calls, but the device can be called only...
hi,I still have not solved the problem if someone can help me describe the problem.the login provided by all the phones that are in the application user RmCm then I in end user devices associated with all that I have to be logged. The login is done w...
I am using IPSEC VPN remote access, the version of ASA 8.4, and tried in the various security section of the vpn but have not found anything. Hello and thank you
I try to explain better to just give an example. I have a phone associated with the RMCM, an end user (AG1) with a device association and IPCC extension. AG1 is configured CSQ in the contact center correctly. Then select another device in RMCM, and I...
Hi, I try to explain the problem in a different and more concise. I have 5 phones in use for UCCX, I can log in from any of the 5 phones? How can I do?
I found the problem and it was: UCCX was working with the codec G711 phones instead work with G729 codec, so I created a special region for UCCX so now works fine...
