Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am a contractor for a company, that has upgraded their access point to a newer model, and they want to factory default their old AP's before donating them to a local school district. (Around 300 to 400 Access Points) What is the easiest way to do t...
I have a customer who is running an old version of prime 1.1. They would like to find out which mac address haven't been on the network in the last 6 months, so they can remove old mac addresses from their ACL. Seems like they could pull this info...
I´m looking for the CLI command to assign an AP to an AP-Group . So the AP's moves from the default AP-Group to the new assigned AP-Group, I can I can do this thru the GUI but would like to do this using the CLI of the controller, when I rename the A...
I´m looking for the CLI command to asign the primary controller name and IP from the master controller. So as AP's join the master controller, I can move them to their new Controller. I would like to do this thru the CLI of the master controller when...
I think were the issue is. Is that some of the access points still have the default username and password? Because, if I can't login to one of the access points with the one that is configured on the controller. The default username and password of C...
Think we found a way to pull the info they require.
Run a report on the Busiest Clients. Let it show: all records. The software says the maximum to show is 50, but I managed to get it to show them all. Go to the end and you'll see who's not been u...
Leo Laohoo Thanks so mush it's a lot easier to assign controller to a large group of new AP's this way.I used this command from the master controller to change them to the NEW controller. and it works GREAT...(Cisco Controller) >config ap primary-bas...
