ADAman
Level 1
Level 1
Member since ‎01-15-2012
‎09-18-2018

User Statistics

  • 149 Posts
  • 0 Solutions
  • 69 Helpful votes Given
  • 20 Helpful votes Received
Recent Badges
1 Helpful Vote
10 Helpful Vote
50 Replies
20 Replies
10 Replies
5 Replies

User Activity

Hi, What is the best way to migrate servers currently on HP chassis equpment to a brand new Cisco UCS chassis? Is there for instance a a HP tool to migrate over to a boot lun? Then we can boot the same servers up on Cisco UCS? Or do we have to rein...
Tomorrow I am going to a customer site in order to try to find out this:They successfully install ESXI to a LUN. They then patch the ESXi server, but as soon as they reboot the blade, all patches are lost and it boots up from scratch. Apparently.I wi...
We followed the Cisco CVD on Vmware and the IP protocol, but we are having problems. The blade initiator does not log into the target igroup (this is on a Netapp controller). No lun is seen at blade bootup. The lun is created, mapped to an igroup and...
We have a customer who wants to connect the iSCSi storage to the Appliance ports on their 6140 XP Fabric Interconnects , because they don't have the Nexus switch and they have too few ports. Is this ok? I know it is not supported by CIsco, but has an...
My understanding is that the traffic from the blades in the chassis or in a C-series rack contains both FCOE and Ethernet frames.But what about the traffic from a Netapp UTA? Looking at the NExus switch config, it seems that all ports in use are Ethe...
Community Statistics
Member Since ‎01-15-2012 09:32 AM
Date Last Visited ‎09-18-2018 10:17 PM
Posts 149
Total Helpful Votes Received 20
Helpful Votes From