Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I want to create DHCP pool in router for 3 vlans. can i create it?
i want to set up layer 3 connection with 2 switches uplink to router(switching module installed), what would be the config i give?
also, both ios-xr switches on hsrp with those 3 vlan...
I purchased 1 controller for my campus. And I place with both core primary & secondary. Is it right place to deploy? & How can I route traffic for corporate clients & guest?
before i was able to access my both ASA's ASDM with proxy setting in my PC. After i upgrade one ASA, can't able to access with proxy setting in PC? I'm still able to access other ASA via ASDM.
Can any one know this ASDM access with proxy setting in ...
Thanks for reply joselgo2!
Done part:-
1) dhcp scope on router which is below:-
ip dhcp pool vlan2network 192.168.2.0 255.255.255.0default-GW 192.168.2.1
ip dhcp pool vlan4network 192.168.4.0 255.255.255.0default-GW 192.168.4.1ip dhcp pool vlan8n...
So with this manner, Do i have to create same VLANs on core switch & do i have to give respective ip to this vlans? and where i can configure Gatway ip? so i can place on controller to send it there?
thank you,
Thank you Alexey,
Here is another thing,We change topology and see attachment below.
Can we still perform LAG? if it is, then how can i configure with one wlc interface to core & another interface with checkpoint FW?
According to topology design, Int...
