Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have created a video peresentation regarding the new clustering feature introduced in the latest sw version of the Cisco Codian MSE device.The video presentation is available at:http://emeatcs1.tandberg.com/tcs/?id=5FE92092-94B7-415F-9921-EECC1F...
Hi,I have created a basic introduction regarding the "IP to ISDN Signal flow"The topics covered are:1. ISDN Overview and ISDN GW advanced setting ( CISCO Codian ISDN Gw platform)2. Expected Signal flow3. Obtaining advanced logs on ISDN GW and basic ...
Well if I am not wrong, you can not choose when you add a new partcipant the call out protocol. However as long as you have a sip endpoint you can simply put the address in the Add Paticipant > Address list and the MCU will call out Regards
Hi Mahmoud, Most likely a firewall inspection issue, probably not allowing 2 video channels from the codec sent to the far end ( you will open a logical channel for audio stream, one for main video channel and then the second video channel for th...
