Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hello alli need to get up an L2VPN between 2 switch ME-3600X-24FS-Mi think the config is fine all show are OK but i cant L2 link doesnt work, no ping between 2 CEhere the show MES.M20.thn.icosnet.net#sho mpls L2transport vc 102 detail Local interface...
hello all;i have PA-MC-STM-1SMI in my 7206 VXR; and i need to configure some link but not E1for first i need to configure a grouped VC3 in one interface,and i have 34M link between 2sites so 14VC12, and i need to have just one interface with 34 M ba...
hello all;i have PA-MC-STM-1SMI in my 7206 VXR; and i need to configure some link but not E1for first i need to configure a grouped VC3 in one interface,and i have 34M link between 2sites so 14VC12, and i need to have just one interface with 34 M ba...
hi alli want to configure a user with privilge to configure L2TP via Xconnectbut i try to add xconnect in my privilge level config but anythink;this is my config privilege interface level 12 xconnectand this is what i have when i try i have this outp...
hello alli did in past a lot of L2TP connection between two end point.in this case ans with 2911 series with ios 15 and DATA license Activated.i The l2tp session does not establishe between a this 2911 and 7209.please FIND attached the topologie file...
sorry for my late i was in travel;i think the best way is to do 3 nat session ;example with 4 eth ( 3 wan e0 to e2 and 1 inside e3)you must creat 3 acl with fragment of your lan example acces-list 1acces-list 2acces-list 3and after configure the 3 wa...
thanks dan;your idea has guide me to the right config ;i add just an event manager to set interface to no shut if the link if the the link is resrablished.this is my config and it's work : ip sla 10 icmp-echo 10.0.0.2 timeout 500 frequency 3ip sla sc...
its depend,tell me, the three connection are puted in the same router or in different router,i must have more information,or if you can post a picture of your architecture
