Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Guys,
Hope someone have some good tips for me.
I'm trying to setup a backup location for Cisco SG300 switches, so i have setup a SCP server and that works good with WinSCP.
When i want to make a backup form my switch SG300 to the SCP server i get ...
Hi Guys, I have a new cisco 887va-k9 with two port of the four with a POE connection. The question only is, how do I turn those?there is no seperate power supply at the back as the old versions.Thanks for advice. Gr Daniel
Hi guys,I have a Cisco 827 and want to turn on SSH.when i do:conf tshow ip ssh% Invalid input detected at '^' marker.Then i want to create a crypto:Crypto key generate rsa general-keys modulus 1024% Invalid input detected at '^' marker.Well, thats st...
Hi Guys,On interface FA0 goes the UTP from my ISP.Futher more I have setup my Vlan1 but i can't connect to the Internet.What am I doing wrong:Building configuration...Current configuration : 3649 bytes!version 12.4service timestamps debug datetime ms...
Hi LP, thanks for your anwser, but the link what you send was for a 867 with 60w power supply. The strange thing is that the 887 has no extra power supply but the rear says it has 2 POE ports.Daniel
Cisco Internetwork Operating System SoftwareIOS (tm) C820 Software (C820-OY6-M), Version 12.2(4)YA3, EARLY DEPLOYMENT RELEASE SOFTWARE (fc1)Synched to technology version 12.2(5.4)TTAC Support: http://www.cisco.com/tacCopyright (c) 1986-2002 by cisco ...
