Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,
I have setup my switch using following link:
http://www.cisco.com/c/en/us/support/docs/lan-switching/inter-vlan-routing/41860-howto-L3-intervlanrouting.html
Everything local is working fine, but when i want to access the internet it doesn't ...
Hello all,
Just a quick question;
I have a router with ip 192.168.1.248 connected on a L2 switch, and all pc's are using this as the gateway.From the L2 goes a cable to a SF300 L3 switch, on this switch i have three Vlan's;
Vlan1 ------> 192.168.1....
Hello all,
Of course a have a question, otherwise i would not be here
When i have the vpn tunnel up, i can't see the office network (192.168.1.0). I only get the ip address from the vpnpool.
Below part of the config i used (or should i post the e...
Hi Reza,
On the switch is ip routing on, otherwise pc's in the 192.168.1.0 can't see the pc's in 192.168.50.0 and 192.168.51.0 and viseversa.
When i do sh ip nat translations, it only shows the 192.168.1.0 subnet in the inside local.
Hello,
I had that two subnets added to the acess-list 102, but it didn't work. So maybe i hoped there was another solution.
Originally my 102 looked like this:
access-list 102 deny ip 192.168.1.0 0.0.0.255 192.168.253.0 0.0.0.255access-list 102 permi...
Hello dinjer2001,
This is what you can look at:
interface ATM0 no ip address no atm ilmi-keepalive no shutdown!interface ATM0.1 point-to-point pvc 8/35 encapsulation aal5mux ppp dialer dialer pool-member 1 !
interface Vlan1 ip address x.x.x.254 255....
