Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi..on IOS versions higher than 12.2(50) on Cisco 3560G-48TS I get this error/traceback, when I reach a certain number of Access-lists group'ed to "interface vlan", and the ACL inserted in the TCAM reaches acl label #128 (can be seen with : Show plat...
Hi.. I seem to have a problem when my access switches are configured with greater than 127 access-lists group'ed to interfaces.The access-list group'ed to an interface with ex:interface vlan 100ip address 10.10.10.0 255.255.255.0ip access-group 2333 ...
Hi,I have a redundant ASA setup using 2 OSPF processors, one for the external core network and one for the internal core network.Normally I have public IP's from the external OSPF being inserted into the routing table on the ASA, and private IP's com...
Hi.I have a network based on (mostly)C3560G switches using L3 and OSPF everywhere except at the access ports where servers are connected. I was planning to use ACLs to restrict packet flow through the router part of the switches. I don't care about t...
Hi,I'm currently backing up the configuration of my cisco switches to a TFTP-server via SNMP using ccCopyProtocol (CISCO-CONFIG-COPY-MIB).Is there any way I can do the same with the ASA5540 firewalls I have?The ASA5540 doesn't seem to support this MI...
The thing is, that these errors only show, when ACL label 128 is in use .. everything is quiet untill I access-group the final Access-list, and then the above bitching and TCAM errors begin It does seem like a firmware (or hardware) bug, it is proba...
The switch is running the following verison at the moment (have testet various IOS versions)Switch Ports Model SW Version SW Image------ ----- ----- ---------- ----------* 1 52 WS-C3560G-48TS ...
The errors are persistent, so I get the same errors efter "power off -> power on"..The TCAM usage is:L3AccessSW10audj#sh platform tcam errorsTCAM Memory Consistency Checker Errors--------------------------------------TCAM Space Values M...
I'm not talking about the access-list number/name, I'm talking about the ACL label, that is inserted in the TCAM. As referred to in the following (for catalyst 6500 though):http://www.cisco.com/en/US/products/hw/switches/ps708/products_white_paper091...
Would it be possible use the area filter-list prefix-list command .. it doesn't seem to prevent the route from entering the routing table.. I might be missing something here?Q: If I split the internal core network into 2 OSPF areas would it then be p...
