Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
My SG 200-08P can't access the web-interface. the problem is without plug the WLAN to switch the LED light is solid green, so I suspect the switch has been setting an static IP address on it. I check the CISCO manual for the SG200-08P don't have rese...
I have an issue setup SG200-08P + LAP1142N to enable the AP work. see attach for the my network diagram
Switch Sg200 direct connect to the router and DHCP has auto assign an IP address to the switch, i have setup and Vlan10 and set the mode to Acc...
Hello Hammel, thank you for your great help. here is the detail of my setting. included the router DHCP setting and Switch VLAN setting. the last is LAP-1142N-A-K9 AP error log. i have reset the AP to factory default setting.. please kind help give m...
