Hi guys, I'm trying to get a proof that my Queueing policy works. I do have Catalyst 9300, so I did apply the Marking policy to one of his end-host interface and then  Queueing policy to the uplink. I so see the counters increasing on marking policy,...

Hi everyone, to prioritize port 22 traffic(to avoid congestion) is the below sufficient? Or it is needed to be added bandwidth allocation like # bandwidth 50; # police 200000 conform-action transmit etc? I mean does the switch prioritize packets base...

Hello guys.The question is about prioritizing SSH traffic from my PC to Linux server: My PC with SSH <-> Cat 9300 <-> Cat 4500 <->Cat 3750< - >Linux server I configured policy only on Cat 9300: 1)access-list 101 permit tcp any any eq 22 2)class-map S...

I have few a  Catalyst 9300 with as VTP clients and Catalyst 4500 as a VTP server.As I understand, pruning enables passing of certain VLANs on a trunk port only if they are explicitly assigned to its access(end-point) ports, but when I run "show inte...

 Hi, we have stack of 3 switches, and when switch 1, which is master, reboots: whole stack is rebooted and then switch 2 & 3 come up with default port configuration, switch 1 has all configuration correct(so we have to configure ports on 2 & 3 each t...