About Gehrig_W

Gehrig_W · 09-08-2023

Hello Cisco WLAN experts,this big hospitals deployed Cisco 9130 WLAN APs also in rooms for patient and call-on-duty rooms for doctors and nurses.To not disturb the night silence by green or mostly blue LED of WLAN APs, we disabled LED- and Flash-stat...

Gehrig_W · 08-11-2023

Hello Cisco WLAN-experts,during implementation and use of the new 9800-WLC-generation, I stumbled over the System Monitoringof WLAN APs which can be activated within the AP Join Profile. Here are the start values:I would like to start using this feat...

Gehrig_W · 08-08-2023

Hello Cisco WLAN experts,I found out that one can activate link latency within an AP Join profile:But where can I monitor the results ?Who has a good tip ?Thank You in advanceWini

Gehrig_W · 08-02-2023

Hello Cisco WLAN experts,this big university hospital would like to use a smart, mobile WLAN-camera solution to broadcast for example a concert from a lecture hall or a church service towards all patients WLAN devices or PCs mounted to their beds.How...

Gehrig_W · 07-05-2023

Hello Cisco Prime Freaks,I would like to filter on WLAN APs in maps using 2.4GHz.But Prime is always starting with a wrong filter-statement of 6Ghz-radio on 2.4GHz-map:Unfortunately I cannot delete the wrong filter argument.I tried in vain already se...

Gehrig_W · 09-10-2023

Hello JPavonM,but normal expectation of mine would be that after I disable the LED, it is disabled totally.It makes no sense to me, that the LED changges from solid state into bliniking permantently in that case.Disabled means disabled for me.

Gehrig_W · 09-08-2023

Hello marce1000, thank You very much for Your information.as soon as 17.9.4 will be a TAC recommended releasae, I will upgrade to it.Kind regardsWini

Gehrig_W · 08-13-2023

Hello Rich R,thank You very much for pointing me to the example in the config guide for AP Real-Time-statistics.Device# show ap config general | section AP statisticsThe shown command within config guide shows statistics but not the WLAN AP they are ...

Gehrig_W · 08-11-2023

Hello Rich R,thank You very much for this valuable tip.So to summarize, this is the CLi-command to check latency values of all APs:By the way, I checked the WLAN APs not showing delay values once again.These are configured with another AP Join Profil...

Gehrig_W · 08-08-2023

Hello marce1000 and JPAvonM,thank You very much for Your valuable responses.The include command is very powerful showing all info for all APs.I was not aware that one can cascade the include special character several times in one line.Here are my res...

Member Since	‎02-01-2017 11:19 PM
Date Last Visited	‎09-20-2023 06:02 AM
Posts	98
Total Helpful Votes Received	11

User Statistics

User Activity

WLC 9800 AP 9130 LED and Flash settings not stable after Reboot

Cisco 9800 AP System Monitoring recommendation

9800-WLC How to monitor Link latency ?

Video Broadcasting via Cisco WLAN

Prime 3.10.3 Wrong 6-Mhz-Filter in 2.4GHz-map

Re: WLC 9800 AP 9130 LED and Flash settings not stable after Reboot

Re: WLC 9800 AP 9130 LED and Flash settings not stable after Reboot

Re: Cisco 9800 AP System Monitoring recommendation

Re: 9800-WLC How to monitor Link latency ?

Re: 9800-WLC How to monitor Link latency ?