Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,Are there any guidelines for how to set the drop threshholds and how to calculate buffer allocation for different scenarios?Is it strictly neccessary to adjust these, or will the defaults values work?
Hi,Quick question, when assigning vlans dynamically to wireless clients based on different radius profiles, are dotq1 tagging required on the access-points?
Hi,I am trying to get my head around QoS on the 2960X platform,with themls qos srr-queue output dscp-map queuecommand, i am able to map dscp values to four queues, butmls qos queue-set outputwill only let me allocate buffers for two, and under an int...
Hi,I have a quick question about how traffic is treated on a switchport(trunk) that connects to an access-point.On the trunk that connects to the access-point i can see dynamic mac-adresses on vlans that i have no mapping for in the flex-connect grou...
Hi,I have my basic rate for 802.11a set to 12Mbit/s, and yet all the clients that associate to this wlan are showing 6Mbit as the only rate. CCX is not supported. I must be missing something here.. What could be causing this?
Alright, The scenario i'm describing is a Flexconnect based solution. So the question is if you are required to enable dot1q taggin on the wireless side, towards the clients
So Then, the question becomes, where do the mappings arise from?Why would i see dynamically learnt mac addresses on vlans that don't have any mappings for?
