Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi there,we have some SVI configured in a LACP Channel from one Cisco 6500 towards two different Juniper devices and running IS-IS.There was a maintenance window and one Juniper switch went down for some time. At that moment only one of our link in t...
Hi there,we have a production network that uses ISIS as the underlay protocol for the MP-BGP / MPLS cloud.We have many IOS routers and two ASR-9K with IOS-XR, all of them configured in the same ISIS domain and area. All of the IOS routers are configu...
HI there,
I am installing new ASR1001-HX devices and I am dealing with the licenses. The current status for feature interface_1g is what I am concerned about. It shows as follows:
sescqrt01nt00fm_ASR#sh lice allLicense Store: Primary License Sto...
Hi. We need to configure 6 devices in a network /28 to see each other in ISIS. 4 of them have IOS and 2 of them have IOS XR. The interfaces are subinterfaces of a bundle. And there is a restriction from the Vendor giving us Layer 2 connectivity th...
HI there,I want to change the extcommunity cost pre-bestpath cost that is comming from a EIGRP route when received in BGP so that an eBGP path is preferred over the vpnv4 bgp path. I have IOS XR and I am not sure if I can just adjust the pre-bestpat...
Hi Giuseppe, thanks for your reply.You are absolutely right about the SVI, it is actually a Layer 3 subinterface.. sorry for the lapsus..About your suggestion in checking the Juniper´s configuration, it is one of the things I was focusing on but as i...
Hi, to clarify the device with the above config is a cisco WS-C6504-E with Version 12.2(33)SXJ7. The Juniper boxes only provide Layer 2 connectivity towards other Cisco routers which are the ones with the IS-IS neighbors.Thanks for your help in givi...
