Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all! I am having an issue getting AnyConnect to properly work on our ASA. The ASA has two internal interfaces, inside & inside2. Inside is a flat, legacy VLAN and is in the process of decommissioning, whereas inside2 is the new interface that is a...
Hello all!
I have applied a VACL to VLAN 11 and everything works, except cell phones cannot get a DHCP address. Windows machines get an address just fine. Has anyone seen anything like this before? Any ideas based off my config? It is setup to allo...
Hello all!
I have recently acquired a new block of CIDR IP addresses from my ISP and I don't understand how to get it setup.
WAN address: 68.x.x.232
WAN gateway: 68.x.x.225
CIDR network: 70.y.y.112/28
Usable addresses: 70.y.y.114 - .126
How d...
Hello all,
I have acquired an ASA 5508-X and am testing a few things out. I got the AnyConnect VPN to work, but I cannot seem to configure site-to-site hairpinning over SSL VPN.The site-to-site IPSec VPN does work and hosts are reachable from both s...
All,
I am looking at setting up SNMP v3 traps on my routers and switches. What software is commonly used to collect (and notify) of the SNMP traps from Cisco devices? I cannot seem to find a clear cut answer, or someone saying, "This is the best SNM...
Okay, I did get it! Thanks for the assist everyone! I already had the network-scope defined in the group policy, but there were some quirks in the environment that needed cleaning up. I removed the static route from the L3 switch for 192.168.26.0/24 ...
@MHM Cisco World No, that still didn't work - I immediately get a no address assigned error. On the L3 switch, I have VLAN 26 configured and its interface to include the helper-addresses of those DHCP servers on the 192.168.22.0/24 network. On the ...
@Rob IngramYes, the ASA has a route for the DHCP servers and the switch does have the ASA as its default gateway. Since I created the pool on the ASA in the 192.168.26.0/24 subnet, I created the new VLAN on the L3 switch and added the static route to...
@MHM Cisco WorldI do have a static and default route from the L3 switch to the ASA Gateway of last resort is 192.168.25.1 to network 0.0.0.0S* 0.0.0.0/0 [1/0] via 192.168.25.1192.168.20.0/24 is variably subnetted, 2 subnets, 2 masksC 192.168.20.0/24 ...
@Rob IngramI did add the DHCP server(s) under the tunnel-group and added the scope in the group policy. I also have a NAT rule in place. Since the configuration below has a DHCP pool from the ASA, the connection and routing does work, but I'd like to...
