PRTG system in place running other sensors on the same host, which are working. Ive added syslog receiver sensor and receiving PRTG data from switch that increases drops, errors and warning stats that disappear after a few minutes. Within messages panel log entries are being logged but only timestamp and source IP address are correctly populated. Messages column displays 0��0 ���00.� and the rest of the columns, timestamp severity etc are blank. Overall sensor is connected but details from system logging are either being misinterpreted at PRTG or not being received . No packets are being dropped at the firewall towards PRTG.
... View more
Topology R1 – [R4] = Area 0 : process ID 1 [R4] – R6 – R7 = Area 1 : process ID 2 I have a loopback interface configured on R6 and R7 which is distributed by ABR and pingable from R1. After adding the filter list and prefix-list its still a routable path to 192.168.177.0/24 from R1. Each area has its own process ID. Config R6# interface Loopback6 ip address 192.168.166.1 255.255.255.0 ip ospf authentication ip ospf authentication-key area1 ip ospf network point-to-point ip ospf 2 area 1 end R7# interface Loopback7 ip address 192.168.177.1 255.255.255.0 ip ospf authentication ip ospf authentication-key area1 ip ospf network point-to-point ip ospf 2 area 1 end I want to filter loopback 7 from creating a LSA entering Area 0 but permit loopback 6 R4# router ospf 1 router-id 188.8.131.52 redistribute ospf 2 subnets router ospf 2 router-id 184.108.40.206 area 1 filter-list prefix FILTER_INTO_AREA_0 in redistribute ospf 1 subnets ip prefix-list FILTER_INTO_AREA_0 seq 5 deny 192.168.177.0/24 ip prefix-list FILTER_INTO_AREA_0 seq 10 permit 0.0.0.0/0 le 32
Can somebody help me understand how I can get this to work.
... View more