About shaikmohib

shaikmohib · 03-13-2017

Hi All, I connected to one of the routers via OOB and now i am stuck in this prompt, i cannot exit. or do ctrl + Z. Only way is to close and re launch -:- hostname cli->--:- hostname cli-> exit Error: Invalid command: exit--:- hostname cli-> exi...

shaikmohib · 06-29-2022

Hey Sean, We have seen something similar in our environment our cat devices support the multiple helper address. But can you share the following output.show ip dhcp relayshow running-config dhcp

shaikmohib · 06-30-2021

Hey,Few things to note.1. Why do we still have access port config on the ports"switchport access vlan 9"2. You are missing LACP config on the ports, you have to set Lacp priorityUse the following commandsint gi <port number as per your setup>lacp por...

shaikmohib · 06-29-2021

Hey John, Follow the below steps for upgrade. You can jump to the latest code but ensure you have the right files copied and perform the necessary tests. show install all impact nxos nxos.7.0.3.I4.7.bin --> I have this in my 5k. This will do an imp...

shaikmohib · 06-29-2021

Hey Eduardo use the following setup to enable both VLan Access Mode Vlan : 1Voice Vlan : 100 You can also use CLI to do the same switchport mode access vlan 1switchport voice vlan 100 Let us know if you still have any issues

shaikmohib · 06-29-2021

Please share the interface config andshow command output for port-channel : show lacp port-channel 1Also this ref doc may come handy if you need to check : https://www.cisco.com/c/en/us/support/docs/smb/switches/Cisco-Business-Switching/kmgmt-2239-c...

Member Since	‎02-12-2017 07:17 PM
Date Last Visited	‎07-06-2022 12:07 AM
Posts	14
Total Helpful Votes Received	11

User Statistics

User Activity

STUCK IN cli-> mode

Re: NEXUS 93180 DHCP relay issues

Re: LAG between two SG350-28 shows only one active member

Re: Nexus 5K to FEX 2200

Re: How to enable VLAN1 and VLAN 100 on all ports on a Cisco Catalyst 3560G PEOP-48 Switch

Re: LAG between two SG350-28 shows only one active member