Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to upgrade a Cisco 9800-L-F WLC through DNAC:
However, DNAC is looking for the Compatibility Matrix file for the current firmware, (which is 17.03.08a )
It seems that the 17.03.08a is end of support, and I am unable to download the requ...
Good day.
I have a wireless network consisting of 9800WLC and 9164 APs
I have some users experiencing Whatsapp Dropped calls, and I have started looking at roaming, as the culprit.
I see under my client Mobility History under Run Latency the followin...
I am busy troubleshooting an intermittent issue on my wireless network, on the 5GHz network.
When I look at the Radio Active traces, I do not see any "real issues" that stand out, however I do so quite a lot of these errors below, but do not seem to ...
Good day all. I have a 2500 WLC running 8.3.143.0 code, and 2802E Access Points.The clients being used is Honeywell A70 Talkman devices. I have users intermittently dropping connections, When looking at the sh msglog, I see the following errors. I ha...
Good Day. I have a 5508 WLC, and need to enable Clean Air. I have no access to a LAB environment, and need to know if the AP will reboot after the Clean Air is enabled ? Also, when I need to change the "channel list" in the DCA page on the 2.4gHz rad...
Thanx for the feedback. Unfortunately it is not a debug, so the tool would not help much. The config Analyzer did not show any major issues. Any other ideas what might cause this issue ?
Thanx Leo ! You 100% sure ? Dont wan't to bring down the whole network . . .. . Also, when I need to change the "channel list" in the DCA page on the 2.4gHz radios ? Regards
Hi. it has never been 100% stable ( i have just inherited it). It is a cold storage warehouse and like I said, the signal is not great (some places -65 some places -72 to -76) Unfortunately, it is Motorolla units fitted on Toyota Forklifts, so I am u...
