Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,If I understand it correctly you have UC500 series with CME and you would like to change the calling party number on outgoing calls depending on where the call is going. Let me know if I misunderstood it. And give me an example with a drawing if p...
Hi,This sounds like a codec issue. The phones are ringing or they only ring once (in case of analog for example) and then once someone picks it up it fails. Can you check the codec used on the call manager? You can find this under System -> Region. C...
Hi Dave,The dialpeers look correct. Although we need incoming peers too. For example:dial-peer voice 100 voipincoming called-number .codec xxUnderstanding Inbound and Outbound Dial Peers Matching:http://www.cisco.com/en/US/tech/tk652/tk90/technologie...
Hi Paul,Your config looks correct. Guide suggests the same:http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/command/reference/cme_a1ht.html#wp1048060I would suggest to open a tac case with us.Best regards,Apor
Hi,You will need to configure the following:Gateway:Add both incoming and outgoing dialpeers on the CME router. For example:dial-peer voice 100 voipincoming called-number .codec g711ulawdtmf-relay h245-al>>> This will match any incoming call and use ...
