hi all,I useing Cisco861 : C861-universalk9-mz.124-24.T3.binon my Cisco861 the command "ip pim dense-mode","ip igmp static-group "command does not exist,router(config)# ip p?port-map prefix-listrouter(config)#router(config)# int vlan 1router(conf...
I am using CISCO861 router.I cannot set track though I want to succeed priority to 20 lowering standby router when the link of FastEthernet4 interfaces is downed. Would there be a place I have to change some setting and check it where? .Is it imposs...
Hi , huwyhuwy123I'm not sure you have help,Did you mean,Do you want your firewall settings? .What is destined to set a route on the firewall XX17.170 255.255.255.252 ?What is the policy of the firewall settings permit PING(ICMP) ?
HI,Cisco 860, Cisco 880, and Cisco 890 Series Integrated Services Routers Software Configuration GuideIt is likely to mistake the cisco web site.http://www.cisco.com/en/US/docs/routers/access/800/860-880-890/software/configuration/guide/vlanconf.htm...
Hi, JayaKrishna.Unfortunately.My Cisco-ID was not able to confirm BugToolKit in lack of a right.I will tried to the update to 12.4(24)T2.and, it was able to set the TRACK command.Thanks a million.