Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all, is there a way to allow publicly available services to have keep public Ip addresses without nat? Our service will work better if there is no nat, static or dynamic.
I have seen some things like NAT 0 but im not sure if that is what im lo...
Hi All,
A question on design. I'm looking for a best practice/design on the subject. I've worked on an NDS that specified 10% of port density be reserved for spare use. By that math, for a 24 port switch that would leave me with 2 or 3 spare port...
Hello All,
I upgraded ASA version from 9.1(2) to 9.3(2). My AnyConnect was set up according to http://www.cisco.com/c/en/us/support/docs/security/asa-5500-x-series-next-generation-firewalls/70847-local-lan-pix-asa.html for Local Lan Access. Prior ...
Good evening all,I'm having an issue setting up my ASA to authenticate to an LDAP server. The ASA is at a remote site and my LDAP server is here at HQ. I have the tunnels built out and am able to pass traffic, (10.48.1.2 --> HQ Private subnets 192....
All, Are there any considerations to make for connecting newer IOS devices to older CatOS?Summary:6509 switch with CatOS 8.7, policer values shaping 20M cos 5. Router connected is 891 with IOS 12.x. Traffic is untagged and being sent at a rate of 20M...
Right, we have bumped up the burst initially but the traffic still never made it past 7M. Is is possible to alter the Tc (Time interval) on either devices? Or perhaps a known fomulaic solution for converting speeds between devices? I know that, fo...
