Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
There are 70 + sites in an organization . There is a 3rd party tunnel to a vendor. Some of the IP ranges overlap with the vendors other client's tunnel . They have asked us to NAT. Each 1 of the sites has a /24 subnet. The NAT they want to provide us...
Looking for away that we can implement remote testing of failover to LTE. The fear is that if failover did not occur we would be down until local status page could be accessed by a onsite resource. How could we safely and effectively test ISP failov...
I have deployed an asav on an ec2 instance in aws. When I connect to it there is only 1 interface (management) . Every guide I have read requires me to configure the gig0/0 interface. It doesn't exist. I can't connect via asdm .
We have a need to build an Ipsec tunnel from a Fortigate in AWS to a VMX100 in AWS. When initially configured we were able to establish Phase 1 . Phase to on the fortigate always showed as failed. We involved Meraki support to verify Phase 2 because ...
So I have a loop because I was unaware that the Ethernet ports on the MX250 could not be used as uplinks for my 6 MS225s because RSTP. Got it. Now I am looking at stacking my 6 switches and using LAG to connect all uplinks. I know the best practice w...
@Francesco Molino thank you. Originally only 4 subnets were need 10.0.30.0/24 10.0.31.0/2410.0.32.0/2410.0.33.0/24Now they want to add additional subnets to the design but the ASAv is limited on the number of interfaces . I cannot add interfaces in t...
After spending time with Fortigate and Meraki today we were able to achieve tunnel connectivity. There were multiple issues so I thought it would be a good idea to post them in case anyone else ever comes across this same issue. First, when establish...
