Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
My VPN Client connects to a PIX 515 with 6.2 OS on it. I have IP connectivity for about 2 to 5 minutes and then it stops and I get the pop up that states the connection has been terminated because the peer is not responding. Below is the log on the...
I have two 3810v, both with 12-1(3a) software and I can not do a show running-config nor a write term command. I am seeing numerous buffer and memory failures, which usually points to an IOS issue. However, I am using this old of IOS to support VoH...
I have VPN client Vers. 4.0 and need to connect to a PIX firewall across the internet. The problem I am having is that I can establish a tunnel, but am unable to utilize the application or even ping the application server on the other side. I am be...
I have just completed a pilot for a customer, On the server I installed IAS and Cert. Services, then installed computer certificates on the server. I had to install both computer and user certificates on the clients, as well as some hot fixes and a ...
Trying to build a VPN tunnel from a 827 DSL router to a Pix515, I have built over 80 of these to the same PIX and had no problems. Now every one I build is telling me the below message in my debugging of ipsec and isakmp. If anyone knows what this ...
Problem seems to have been with the nonat acl, which was also being used for split tunnel, I made a acl just for split tunnelling, omitting all the unneededs in my nonat acl, i.e., DMZ access and various other things that I did not want to remove and...
While it is connected, I CAN get data across. If you look at the Client log I am not recieving the (HASH, NOTIFY:DPD_ACK). Below is a log from a good vpn connection to another client. Notice that when there is a (HASH, NOTIFY:DPD_REQUEST), an isakm...
