About narmali

narmali · 10-24-2017

I am using one 100G line card (N77-M312CQ-26L) on Nexus 7710 Chassis. I am configuring VRF to all the ports of 100G line card to run L3 traffic. First two port of the line card connected to Spirent Test-center to send and receive the traffic and all ...

narmali · 03-16-2017

Doing testing with "WS-C3650-12x48UZ-SV01" fresh switch. I want to use USB in switch for booting some images but, Switch is not detecting the USB. Kindly, help for the same.

narmali · 03-06-2017

Doing testing with "WS-C3850-12X48U-L" product. When I boot the ios image into the switch, I am getting "cisco>" prompt then after enabling it, it ask for the password. After giving password it comes to "cisco#" prompt. Now, I want to remove this pas...

narmali · 10-24-2017

when I loop back both line card ports (1 & 2) it works. I am using same QSFP (100g-SR4-S) as that of Line card ports, on Spirent side. After connecting to individual ports of Spirent and giving configuration commands, it shows Link not connected.

narmali · 03-16-2017

I am using HP 16GB pendrive which supports to same 3650 series another "WS-C3650-12x48ur-lv01" switch. But for the above mentioned switch its not supporting.

narmali · 03-06-2017

Thanks Julio Moisa, for your valuable response:-) Regards, Narpat Mali

narmali · 03-06-2017

Hi Julio Moisa, You got my question correctly. But I also want to change my "cisco#" prompt to "switch#" prompt. Now its coming like below picture. Thanks for your commands help. Thanks & Regards, Narpat Mali

Member Since	‎03-06-2017 02:15 AM
Date Last Visited	‎06-12-2018 04:39 AM
Posts	7

User Statistics

User Activity

100G ports VRF Configuration "Link not connected"issue

Network switch External device detection issue

Network switch prompt issue for product "WS-C3850-12X48U-L"

Re: 100G ports VRF Configuration "Link not connected"issue

I am using HP 16GB pendrive

Thanks Julio Moisa, for your

Hi Julio Moisa,