Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have several remote sites connected to us via Layer 2 connections using several different providers. (EPL, ASEoD, wavelength) We'd like to encrypt the traffic on the /30 network between each site. What's the best way to do this? IPSec tunnels? ...
I have a WS-C3850-48T. I was doing a transferrer between two 10G interfaces and noticed my monitoring system was alerting me to high utilization. Looking close I saw that the VLAN shared between the two interfaces is only showing 1G. A "show interf...
WS-C3850-48T Version 16.12.08 I setup a port channel for a Mac Pro with two NICsinterface Port-channel1switchport access vlan 100switchport mode access!interface GigabitEthernet1/0/13switchport access vlan 100switchport mode accesschannel-group 1 mod...
I'm currently have several WS-C3850-24T, 16.12.08 (CAT3K_CAA-UNIVERSALK9)I'm monitoring with Observium and it's showing that the current temperature value is beyond the "Min Warn" value.This value is being read from the devices. (if I manually chang...
I have an ASA 5555 (9.14(2)15)it has an inside IP of 10.255.90.1 getting BGP routes from the VPN. I'm able to reach this ASA from the remote side of the VPN. I can ping it, SSH to it and connect via ASDM. I cannot however connect to SNMP on the in...
I was guessing this might have been happening. With my limited undemanding of STP, I thought L2 loops would be prevented. I suppose I don't have STP configured properly. Any guidance on where I can find some documentation on what I might need to st...
Thanks Georg,
With that command NAT is working now. but... I'm back at the original problem of having the SSH, HTTPS, TELNET port exposed to the public on the ip of the outside interface, x.x.56.146
Is there a different way to designate which int...
