Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I just purchased a used UC520W for home office. I reset to factory defaults by copying the factory config (UC520W-16U-4FXO-K9-factory.cfg) to the startup.I plug a PC into 0/1/0 (1st of the 8 POE Ports), and the machine is not reciving a IP from DH...
Hi, I just purchased a used UC520W for home office. I reset to factory defaults by copying the factory config (UC520W-16U-4FXO-K9-factory.cfg) to the startup. I plug a PC into 0/1/0 (1st of the 8 POE Ports), and the machine is not reciving a IP from ...
Hi, I just purchased a UC320W, Did a factory reset, and try to access it via the default 192.168.10.1 address, and the blue cisco page loads (has cisco logo, and green bar), however, it never kicks over to the login page for me to start the configura...
Hi, I am opening a mid sized retail shop. I have (2) 7970, (4) 7940, and (1) 7925. I need 1 auto antendant menu (when call comes in via fxo line), 1 FXO Line for in/out bound calling, and 1 voice mailbox that sits on an extension. Would it be possibl...
Hi, I am currently switching out our Cisco 1130 APs and Cisco Small Bussiness APs for Cisco 1142Ns (I will NOT be using a WLC), I have setup the AP, and read about some issues with Multicast and Apple Bon. Services. I ran the "no ip igmp snooping" co...
Thank You. I have downloaded the pack, and go to install/upgrade before doing a restore in CCA, and the wizard hangs up at the "Ping Test from CUE to CCA". Im going to reboot everything and give it another try now.
Thank You. I was able to get access to the UC520 via CCA via the 192.168.10.1 address. However, when loading any of the telephony items, it says "loading voice related data"..The progress bar fills up and it keeps going, right now this one has been u...
I ran those commands, and also set an ip address for the Integated-Service-Engine0/0PC gets address from DHCP when plugged into POE switch port 1. Address is 192.168.10.2I open CCA, I try to add 192.168.10.1 or 192.168.9.1 (Integated-Service-Engine0/...
Hi Trent, Thank You. Below is the "show run interface fa 0/1/0" and the "show run" as "show run | see dhcp" did not return anything. Router>enRouter#show run interface fa 0/1/0Building configuration...Current configuration : 35 bytes!interface FastEt...
