Hi,
I just purchased a used UC520W for home office. I reset to factory defaults by copying the factory config (UC520W-16U-4FXO-K9-factory.cfg) to the startup.
I plug a PC into 0/1/0 (1st of the 8 POE Ports), and the machine is not reciving a IP from DHCP. I tried to set a static IP, etc however no matter what I do I cannot connect to the UC520 from CCA.
This UC520 will be used only for Call Manager. Wish to just plug into network along with the phones. Routing & switching is done with other cisco gear. Also, I wish to use the WLAN in the UC520 for a single ssid for my 7925's to connect to.
Phones & PC's are all on one VLAN now.
Any help would be appeticated.
Thank You!
