Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Guyz,Is there any way to assign one than one VLAN to a switch port and what commands we need.I don't interface to be configured as trunk.RegardsWasim Abbas
Hi Guys,I just passed my BSCI but have a question regarding the simulation. In sim I had to configure EIGRP delay with 10ms. Its basically a redistribution in isisrouter eigrp 100redistribute isis level-1 metric 256 10What I'd like to know is do we j...
Cisco 3825 running advanced IP Services and the Version is 12.4(11t). The IPS is not working properly, someone recommend they upgrade to a later version.What damage can be done by upgrading to a later version?
What I've is nearly 3000 3Com 4400 series switch located in all 550+ M&S stores and I do configure those switch ports in multiple VLANs. Just digging around how this can be done on 3Com and not on Cisco.Regards
Thanks Ankur for your reply.Well very basic question. I go again here.Lets say interface 12 is in VLAN2 and I need it to be in VLAN3 as well.In other words 2 dirrent VLANs for same interface.Can this be done?Regards
thanks for your reply Paul, well my customer is using SDM 2.4 to configure IPS and get error "IPS may not be working properly on 12.4(11)T and 12.4(11)T1 images. It is recommended to upgrade the router's image to 12.4(11)T2 or later"or Shall he try S...
