Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All, Could someone confirm how the CTMS handles the speaker switching mode in the below particular scenario.Let's say we have 4 CTS3000 rooms that I will name with each of its segment below: Sunnyvale: SUN1, SUN2, SUN3SanJose: SJ1, SJ2, SJ3Tokyo: ...
Hi there, Does somoneone knows if CLID feature is possible if using CAS signaling on an E1 ? While connecting an Ericson PBX to a 26XXX using the following parameters, everything is working fine but we don't get the CLID----controller E1 1/0 framing...
Hi all, as existing equipments locations are sometimes not easy....I have one of my router (7204VXR/225) with my module (PA-VXB-2TE1+) in a room and my PBX in another room (in order to do PBX interco on E1)I am searching the maximum distance limit be...
Hi all, I'm trying to find out if the 7100 can support a PBX interco (either on E1/T1 or FXO/FXS/E&M)I did not find any VOICE IOS for this plateform neither any voice interface...Does someone confirm that this plateform is not compatible ?Thanks you ...
Hi everybody, did not manage to find that kind of information the cisco web site.Searching a table/matrix that could give me an average of the time that is needed for an equipement to boot.I already agree that this will depend of: * hardwar...
Hi Gonzalo, Since the system is supposed to display the segment in its proper position (as you rightfully say so) I would have thought that in Sunnyvale, you can NOT see at the same time the center segment (segment 2) of the 3 other rooms as they are...
Thanks Chester, now that I know that technically this is supported, I will go back to the PBX Vendor (Nortel) to see which R2 flavor he can configure on his PRA. I will let know the forum the outgoing of this:Regards
Yes it follows the same rule. All CTI ressources can be load balanced (Cti ports and CTI route points)This was a huge improvement made with 3.1, since the creation of the CTI manager that is reponsible of the failover/failback and rehoming of the CTI...
What do you mean bu the correct messages ? When a phone goes out of service (ie. when it's unplugged) an OUT_OF_SERVICE msg is sent through T/J TAPI. (IN_SERVICE when a replug/restart)So the question is do we have the same message when a user lougout...
Same answer as for Netwise :))ArcSolutions is also part of the AVVID Partner Program and has been verified on either 3.0 and 3.1See the Cisco Web Site for additiona info.If you want more info regarding the product you should contact your regional Cis...
