Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, We've been having an intermittent issue where clients seem to drop their connectivity intermittently. We have an SSID configured with 802.1x and user-machine authentication using MS-PEAP. ISE is currently used as the radius server,Synopsis:When...
Problem Details: Hi,I've recently migrated from PIX to ASA5540 Version 8.0(3)6. On the new ASA we've setup L2L tunnels andRemote access and everything seems to be working fine. However, we have a radiologistgroup who are using VPN remote access via t...
Hi there.I have setup EAP type authentication using MS-PEAP V2, everything works fine. The issue is when using PEAP, users must authenticate before network connection is established. However, this introduces another issue, I cannot for example, push ...
Hi there.I have setup EAP type authentication using MS-PEAP V2, everything works fine. The issue is when using PEAP, users must authenticate before network connection is established. However, this introduces another issue, I cannot for example, push ...
I've configured my AP wireless device to authenticate using LEAP via Cisco ACS 3.x. everything works fine as long as the NT user ID is associated with a password. However I do have a generic user ID that is used by a quite a few employees and it doe...
I've had a TAC case open with Cisco for a long time and we've exhausted a tremendous amount of troubleshootings packet captures and so forth. Then it got escalated to a higher level and was decided to upgrade to the latest image before proceeding wi...
Thanks for your reply. Currently I have the TCPMSS set to 1280 and clear-df on the outside is also enabled. I will try to lower the TCPMSS to 1260 hopefully I'll have a better results. I'm also planing on upgrading the ASA to the latest software imag...
What kind of issue is your client having? I'm having an issue where the clients are freezing up while they're using the application, even though the tunnel status is up, after a few seconds they're back to normal. This happen intermittently. Cisco su...
Thanks for getting back to me. I did change the The idle time out value to not to expire a few weeks ago,unfortyantly that didn't do it. However, I did capture some traffic and sent it to Cisco TAC for futhher evaluation, they came back telling me th...
When you first create a VLAN by default the VLAN interface is shutdown. You need to go to your MSFC if that is what you're using, change to the VLAN interface and issue the no shut command.
