Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Team,
I am using Cisco CP-8831 and i am registering it in Cisco 2911., its not registering. I am getting the error as Phone not registered. Pls find the debug out from
debug tftp events
*Feb 9 07:13:46.207: TFTP: Looking for CTLSEPAC44F21319D1.tlv*...
Hi All,I am not able to configure the neighbor ip-address as-override command on my cisco 2821 router.My router ios - c2800nm-advsecurityk9-mz.124-15.T9.bin.What should I do for that command to work on my router?
Dear All,I am trying multicast video stream in my network but it is not working between Vlans. But its works fine in the same vlan. Using VLC for video straming. Router, switch and pcs are connected as given in the below link.http://www.cisco.com/en/...
All,I have configured the router and modem as per the config given in the below link but it is not working. I am able to dial and successfully connect the modem but there is no display on the hypertrm.Is there anything I need to check. I am using cis...
All, While logging to cisco works I am getting below error.You don't have permission to access /cwhp/LiaisonServlet on this server.Additionally, a 403 Forbidden error was encountered while trying to use an ErrorDocument to handle the request. I hav...
Hi,Its correct.No use of adding "neighbor as-override" in CE side router.Moreover this command is the MPLS command and can not configure on my CE as I am using BGP.
Jon,I am facing network issue with one of my MPLS service provider.The specific network AS travell path is repeating.In the show ip bgp output we found that the AS is repeatingExCE-ROUTER#show ip bgp 10.180.8.64BGP routing table entry for 10.180.8.64...
Hi Jon,Thanks for your valuable reply.I got clarified.What is the difference between the MPLS and BGP configuration. Do share if you have any document.
