Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am just wondering if I have missed some safety features that come with the ASA 5510 that would cause the DEBUG not to stay up (such as debug icmp trace). I am running ver 7.0(4) in two of our ASA 5510s and found that the Debug command I issued wou...
Hi tepetal,We have two routers currently running IRB via their serial line (there is actually another router in the middle to bridge). I am thinking of using ISDN to back up this line. However I understand that ISDN does not support IRB. Is it pos...
Can somebody verify that if it is possible for vpn client connecting on the same segment as the VPN private interface to come in through this interface to authenticate and then pick up the proper grouping and filters to access the private network ,ag...
I have configured the Cisco VPN3005s before. However I have come across a problem that I cannot resolve. In this situation the VPN client cannot ping to any devices on the private side of the VPN. The client when VPN in show the secured route to th...
Ray,VPN 3000 has a very good logging and you should be able to tell what event it was just before it went down. If this happens everyday at the same time, take a look at Administration/System Reboot to see if you have scheduled a daily reboot.
Hi Arul,I was the only one logged in for sure. I actually have 2 ASA 5510s with the same code level that I have tried. I issued the command debug icmp trace on command line and send the debug to my screen. The debug works and shows up when I do a S...
Thanks for your response. Yes, I meant the VPN 3005. I was hoping somebody would know about a third party software to do this. XML is still not the best to view it. Thanks again.
