Hi All,Is it ok to define WCCP in both directions on the serial (WAN) interface using two different WCCP service groups? The NAT is performed on the router. We would like to have client source ip in the NAT table instead of the WAE as inside address....
Hi Guys,I have a failed 6506 IOS switch. Can you look into it and see if its a chassis problem or module problem ?06/29 16:07:10.434 E [3] check_ether_packet [3/21]: newpak is NULL!06/29 16:07:11.106 E [3] check_ether_packet [3/22]: newpak is...
Hi All,Is there a way in EIGRP to prefer external routes versus internal routes. EIGRP always picks up internal routes as long as they are available, no matter if external routes have better metric. Our Scenario is that we have DMVPN hub and spoke to...
Hi All,I have a network scenario involving EIGRP routing between Cisco 6500 and two 3800 routers. The Internet T1s are connected on the 3800 with two T1s on Rt1 and one T1 on Rt2. I have setup EIGRP unequal load balancing on 6500 with variance 2 so t...
Has anyone configured NBAR for Citrix ICA priority tagging ?I have configured NBAR for Citrix ICA priority tagging feature on a 3845 with 12.4(13c) IOS.The citrix server is on a lan g0/0.1 connected to the DMVPN hub router.The citrix admin has config...
Hi Rick,Thanks for your reply. Your explanation looks exact to what I see. I am going to try out some config changes in the lab. As I said before, until there are internal routes learnt by EIGRP, it will not try to install any external learned routes...
Thanks everyone for replying back to my post. I tried reducing delay, reducing external AD vs internal AD for EIGRP, it didn't help at all. EIGRP always picks up the internal routes vs external routes even though external routes have better metrics. ...
You might want to check the MTU size over GRE IPSec tunnels. Usually you see poor performance over GRE IPsec tunnels when the packets are fragmented by the intermediate routers. See below link:http://www.cisco.com/en/US/tech/tk827/tk369/technologies_...
