Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,We have a couple of ASA5580s on our network edge deployed in a Active/Standby configuration in routed mode running 8.2(3).The devices log to both a MARS 210 and a Linux Syslog server at the informational level.MARS insists that the log level sh...
Hello,My MARS is complaining that the battery on it's RAID controller needs replacing:You are receiving this message because the RAID Battery Back-Up Unit (BBU) requires replacement soon in order to ensure that the CS-MARS system continues to perform...
Hello,It appears that all end-users have to translate roughly 750 text messages complete with placeholders & escaped symbols to the language of their choice with the AnyConnect 2.5 client.I'm looking for Canadian French translations - Surely someone ...
Hello,I have a network on my pix that uses RFC 1918 addresses in the 10.0.Y.0/24 with the pix interface as 10.0.Y.1I have multiple interfaces which I need to translate some of these addresses from 10.0.Y.X <-> 192.100.255.Z so that the hosts on the p...
Hello,I have a couple of servers i'm moving to a DMZ. They currently exist on an inside network behind a pix 535 (6.3(5)) with public addresses that are well known. They are on a /24 with numerous other hosts that need to keep their existing addres...
So we finally bit the bullet and upgraded to 4.1(7). The DCERPC inspection appeared to work for that traffic which we noted previously was broken. Only problem is that WMI queries which used to work are now broken.Opened a case with our PICA back i...
Thanks Mike,We went through that exercise during our initial MARS deployment using the list of suggested events in the MARS documentation but found that 99.9% of the messages were 106023 (Denies) and Session initiation and teardown messages that MARS...
Marcin,The section in the AnyConnect Admin guides about the french & japanese translates being available disappears in the ver 2.4 guide (i.e. is there is 2.3 & earlier). The files on the site with "lang" in the filename are just the mst language tr...
OK - got it figured out.I imported the config from the old ASA which someone else had configured (incorrectly).As you pointed out I only needed the static in the outbound direction not inbound as well.adding:static (inside,outside) netmask 255.255....
