Vinoth, can you ping the secondary addresses from one another? This will have to be done using an extended ping sourcing your secondary IP address. I noticed that the primary IP addresses of both routers are in two different subnets which suggests ...
John,since you shut down the router the BGP peer immediately broke causing the convergence. The 60 second keepalives and 180 hold time were not involved in this process since your interface went down. To test those timers you will need to maintain ...
Ken,1. DWDM typically refers to lambda or wavelength rather than frequency. DWDM systems primarily use C and/or L band ranges which start around 1500 nm and go higher. 2. Not sure why wavelength is used instead of frequency. Obviously there is a...
I would configure the following, "diagnostic bootup level complete" and reload the switch. This will do a complete diag and once the switch is up perform a "sh diagnostic result".
