Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, I have a switch that when turned on the System light starts blinking orange. When I connected to the switch with the console cable I got this: Image Loader 1.0.1 Loading Diagnostic Image File : SRW224G4P_SRW248G4P_boot.bix ...
Hi, I have a problem with connecting my router 2800 to another router 2800. Both routers only have one interface FastEthernet 0/0 available, the other one os allready taken. This part is simple I put the ips on both interfaces and the connect to each...
Hello,I hav ASA 5550 with 9.1(2) IOS and ASDM 7.1The problem is connecting to this asa with asdm and connecting to https. I tried every thing I know.I downgreadet java and tripple checked my configuration and even erased the whole c...
Hi,I have a problem. I need to connect a modem to my cisco router 3845. The modem only has DB-9(RS232) connection to network infrastructure.How do I connect to the router? Can I use the aux port for network connection? The available connections on ...
Hello,I have Polycom VVX 1500 and would like to set it up with my cisco 3825 Router with Call Manager Express. What do I need to download (like the flash for cisco phone 7971) and how to set it up.lpTomaz
Thank you for solving my problem. My problem was that in my non mobile routers I didn`t create Subinterfaces but instead just entered:interface FastEthernet0/0 ip address 10.0.0.2 255.255.255.252 vlan-id dot1q 2 exit-vlan-config
Yes I realize that using secondary ip addresses or subinterfaces does not work. I am looking for someone that can help me solve my problem or steer me in the right direction, like Jon Marshall that suggested that I try with DHCP (thx again for that J...
Sweet suggestion did not think of that. But unfortunately our company security policy does not allow DHCP addressing I can only use static IP addresses. Thx for the suggestion
Ok I checked for 3DES-AES and it is on. I checked with the config and its correctly configured.Yes I have opened the network with http command.I was so fristrated that I went and downgraded my asa from 9.1(2) to 8.0(4) with the curent running config ...
