Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
According to the open caveat below ipsec does not function in any version of PIX OS 6.1, it's not mentioned as a caveat of even resolved in version 6.2Does anyone know of a version that does work"CSCdu35560 netbios does not work with certain IPSec en...
My VPN clent successfully creates a tunnel with the PIX.If I view the VPN Client log I see that all the addresses for DNS WINS etc. are being processed.I can ping anything at the end of the tunnel, can ping the WINS servers. For some reason the WINS...
Hi,I have succesfully created a IPSec tunnel to a PIX, the problem is that sometimes I can't connect to the PIXI have enabled ICMP on the PIX, I can't ping form outside.If I send a ping out of the PIX from behind I can then ping from outside and also...
I have configured a PIX to opercate with the VPN Client 3.5Everything works well but, WINS resolution will not work.The correct WINS addresses are being issued, you can ping the WINS servers but still does not work.Can anyone give me a suggestion why...
I know this sounds quite simple to troubleshoot but,I have installed a 2620 and two 1601 routers to replace some very old routers between 3 sites (hub and spoke)The very old routers were set to bridge and worked pretty well (small network), So basica...
I can see what you are saying but,how can it be that when you send a ping from the secure side of the pix out onto the net that you can subsequently then ping the PIX from the net and bring up the tunnel.Surely any ACL or lack of it still stop the co...
the arp thing was not an issue, arp entries are there at either end..Telneted into the router next to it and still cannot ping it from there, it's on the same segment too!!Do you think the PIX could be faulty?I simply can't understand how sending a p...
There are no access-group statements in the config at all.The IP I'm trying to ping is the internet facing port of the PIX.The ping must be getting though because it passes the router before it, it's just not getting backDo you think this could be an...
I'm expecting to see, alerts for high processor utilisation and memory alerts.I have ensured the thresholds are low enough and pushed the 2610 above these thresholds, e.g 1% utilisation threshold for CPU!I'm reciving traps for the up/down status of i...
