Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,is it possible for me to configure the router such that the 2 FE interfaces on my 7507 router are in the same subnet? I intend to connect 2 servers in the same subnet directly to the ports as I have 2 spare ports and do not intend to install anoth...
Hi,my company have 2 links to the same ISP currently and the internal network is running ospf. Both my current internet facing routers actually are injecting default route into the ospf with the "default information originate" statement in the router...
Hi,Can someone help?The network diagram as below:-Internal network --|FW|--|7204|--External Network****************************|****************************|*********************Management VlanAs you can see above, I have 3 FE interfaces and I am try...
Hi,anyone has any idea how I can allow a client at the outside int of the pix to get a ip from the dhcp server at the inside int? Is setting up a dhcp relay agent at the outside the only solution?Thanks and regards.
HI, could I check since you are using RSP720-3C for full internet routing, do you hit any problem with users not able to reach certain prefixes since non-xl could only takes 256000 routes? Thanks.
Oops, I think you have misunderstood.Yup, the 2 routers are indeed receiving default route from the ISP.So I think everything should be fine right.I have always thought "default-information originate" is a command to manually generate a default route...
What I suggest is using route-map with a "ip next-hop verify". This would work if both routers are cdp enabled. Once your primary fails, it should switch to the secondary when the cdp neighbour is down.You can change the cdp timeout to a shorter peri...
Thanks for your prompt reply.Do you mean that as long as both my router has the gateway of last resort pointing to my next-hop towards my ISP and w/o the "always", the failover should be automatic??But I don;t quite get regarding the default is prese...
