About D R

D R · 09-24-2020

Hello. I have an ISR 1117 running IOS-XE 17.1 that has an IKEv2 tunnel to a hub site. The ISR is connected to 3 internal networks via L2 trunks and the ISR has an SVI for each network. All networks can be summarised to 10.0.0.0/24. The individual net...

D R · 08-19-2016

Hi all. Has IOS-XE gained support for any of the following? Using loopback interface for OTV join-interface.OTV tunnel depolarization. I know in NX-OS 6.2(6) OTV tunnel depolarization was added. Using a loopback as the OTV join interface was target...

D R · 08-18-2016

Hello. Assuming the topology in the attachment (inline OTV with unicast mode), an extended VLAN is currently flowing via DCI circuit 1.Assume the DCI circuits are not dark fibre but are an ISP provided layer 2 circuit so in theory there could be a ci...

D R · 09-24-2020

I've managed to frig it. The trick was to add routes for each dummy network with a bogus next hop. Obviously the next hop can't be the same router and the route won't install unless the next hop is reachable, so I created a loopback in the same netwo...

D R · 09-24-2020

So I had a thought. I could add a secondary IP to each SVI, thus: int vl10 ip address 10.0.0.62 255.255.255.192 ip address 10.1.0.62 255.255.255.192 secondary no ip redirects no ip proxy-arp ip nat outsideint vl11 ip address 10.0.0.102 255.255.255.19...

D R · 08-24-2016

To close this out, loopback join interfaces are not supported on ASR1k.

D R · 08-22-2016

In case someone else finds this... I raised a TAC case with these questions. Loopback join interfaces have been on the roadmap for ASR1k but there's no documentation to say that it is supported. An internal question has been raised with the BU regard...

D R · 08-20-2016

Hi Madhu. Thank you for taking the time to reply. Great information and insight. As per your comments, I will modify the design and include redundant connectivity for the OTV internal interface via port-channel. The ASRs are connected to 6500 chassi...

Member Since	‎08-18-2016 07:55 AM
Date Last Visited	‎09-25-2020 12:05 AM
Posts	8

User Statistics

User Activity

Destination NAT network and source NAT on ISR

IOS-XE OTV loopback and tunnel depolarization support.

Inline OTV with multiple DCIs - DCI failure question.

Re: Destination NAT network and source NAT on ISR

Re: Destination NAT network and source NAT on ISR

To close this out, loopback

In case someone else finds

Hi Madhu.