Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
How do I learn cisco unified communications? I want to build a working system. I have (4) 2811 routers and (4) 3750s.I can purchase cisco phones. Most of the documentation refers to "clouds" and broad level architecture. Can I install cucm on 2 s...
Hello,Can I use the 1841 FastEthernet0/0 as the connection port to my ISP?I have a T1 WIC, but am switching to an ethernet circuit from my provider.Also - do you have configuration examples?Thanks!
Hello,I'm working with a Catalyst 5509. We can log into the router module, but not the switch module. When logging into the 5509 switch, the system prompts for enable password. After the password is entered - the session stops. There is no respon...
Thanks,I didn't capture/log the session yesterday. We are going to try again on Monday. It's a live cut-over from T1 to ethernet WAN. Is there anything that I can try with the access-list possibly?Someone else programmed the router. That person d...
Hello,Me again. I think there might be an access list issue. We performed the cutover from T1 to Ethernet. This is 1841 router with T1-WIC that is working very well. We decided to use fa0/0 for a new ethernet WAN connection and get rid of T1.The ...
Thank you Jerry!I got dropped in an urgent Cisco project and really appreciate your help. This system will be cut-over live and I want to double check everything
I am using static.Is this correct?int fastethernet0/0ip address 168.215.69.130 255.255.255.252no shutdownip route 0.0.0.0 0.0.0.0 168.215.69.129Attached is "sh config". Thanks for help.There are all types of commands issued to the existing serial0/0...
