Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We just recently upgraded our eligible APs to 30.7 from 30.5. Immediately afterward all 802.11 auth attempts to our RADIUS servers failed. Thus, we rolled back to 30.5. Has anyone else encountered this issue? I see in the 30.7 release notes a ref...
Has anyone encountered an issue with high latency within a MS350 stack? We recently had an event where suddenly one day extremely high latency (800-1000ms) was occurring between the stack's management IP (that also serves as the gateway for remote d...
Is it possible for the PIX to handle L2TP, Cisco VPN Client, and Site2Site IPSec configurations all with pre-shared keys? If so, where might I find a config example. We currently have a home to branch office site2site IPSec tunnel, along with Cisco...
I usually try to avoid vendor issues but I wanted to run this by the forum to see if by chance anyone has run into this...We have a PIX 515 with 6.3(5), and are using a CipherTrust IM Mail Filtering Appliance. For whatever reason, outbound connecti...
Just attempted to upgrade a 1100 from 123-4 to 123-7. Boot fails (three green solid LEDs for 1-2 mins and then a red status. Unit reboots, over and over). Tried to load it via TFTP with the same result. Reverted back to 123-4 and all is well.Anyon...
Just read it (pun intended). You have got to be kidding me. Our affected SSID is in slot 9. Now I haven't fully tested it yet, however, if this is the reason, this has to be one of the most absurd bugs encountered in my entire 30 year IT career. ...
